The EVSE detected absence of voltage after enabling contactor.
The EVSE detected voltage on charging pins when the contactor is open.
The emergency stop button was pressed.
The EVSE detected that the cable has been disconnected.
The EVSE has an unbalanced current supply.
The EVSE detected Live and Neutral are swapped.
The EVSE is unable to obtain electrical measurements.
The EVSE is not in an error state.
Any other reason.
The EVSE detected charging current higher than allowed by charger.
The EVSE internal temperature is too high.
The EVSE input voltage level is too high.
The EVSE pilot signal amplitude short circuited to ground.
The EVSE has detected a loss in power.
The EVSE has detected another power quality issue (e.g. phase imbalance).
The EVSE input voltage level is too low.
The EVSE could not determine proper power supply level.
See
MatterSpecification.v13.Cluster ยง 9.3.7.3